CUTTING FORCES BY OAK AND DOUGLAS FIR MACHINING

Vista sencilla de ítem
dc.creatorBolesław Porankiewicz
dc.creatorGiacomo Goli
dc.date2014
dc.date.accessioned2026-07-07T04:37:43Z
dc.descriptionIn this work the multi-factor, non-linear dependencies between main (tangential) FC and normal (radial) FN cutting forces upon two machining parameters by up-routing and down-routing wood of Douglas fir (Pseudotsuga menziesii) and Oak (Quercus petraea) were evaluated. The relationships are graphically illustrated and discussed. The obtained data were compared with cutting forces evolution models according to grain orientation from the literature in order to verify if literature statements or models comply with measured data. Evidence of several contradictions was found relative to results from available literature.
dc.formatapplication/pdf
dc.identifier0717-3644
dc.identifierhttps://www.redalyc.org/articulo.oa?id=48530204006
dc.identifier.urihttp://hdl.handle.net/123456789/467460
dc.languageen
dc.publisherUniversidad del Bío Bío
dc.relationhttp://www.redalyc.org/revista.oa?id=485
dc.rightsMaderas. Ciencia y Tecnología
dc.sourceMaderas. Ciencia y Tecnología (Chile) Num.2 Vol.16
dc.subjectAgrociencias
dc.titleCUTTING FORCES BY OAK AND DOUGLAS FIR MACHINING
dc.typeartículo científico

Archivos

Colecciones

Maderas. Ciencia y Tecnología - Universidad del Bío Bío